Debugging the NTS-6000-Radio
Posted by , Last modified by on 10 August 2012 16:23

Follow the instructions below to debug and NTS-6000-Radio unit.

Debugging the NTS-6000-Radio (for advanced users)

Log-in to the web admin page. The default username is “admin”, and the default password is “password”. Then go to “Configure SSH Access” and enable SSH.

To connect via SSH using putty (download link below) the default username is "root" and the default password is "galleon".

Press "q" followed by enter to break out of the menu system.

Now stop the Radio service using the command below:

Note: In the command below the single speech marks are "Acute" on an English keyboard they are generated by using the key above tab (failing that copy and paste the command).

kill `pidof radioclkd`

And restart the service using the following command:

radioclkd -t clk

You should see debug information like this if the Radio is synchronised (please allow up to 5 minutes for information to start apearing):

DCD:   1    0      1668

DCD:   2    0      1668

DCD:   3    0      1668

DCD:   4    0      1668

DCD:   5    0      1668

DCD:   6    0      1668

DCD:   7    0      1668

DCD:   8    0      1668

DCD:   9    0      1668

DCD:   10   0      1668

DCD:   11   0      1668

DCD:   12   0      1668

If you receive nothing check the cabling, correct reception should be one message per second.

Note: When you have the antenna working break out of the debug with “ctrl + c” and then reboot the unit using the command “reboot”.

Putty Download Link:

(0 vote(s))
Not helpful

Comments (0)
Post a new comment
Full Name:
CAPTCHA Verification 
Please complete the below captcha challenge (we use this to prevent automated submissions).