Knowledgebase
1Whitepapers 50Network Time Servers (NTS) 8Time Servers (TS) 7Atomic Clocks (AC) 5Digital Clocks
Knowledgebase: Network Time Servers (NTS) > NTS-6000
Manually set the IP Address
Posted by Stuart Thomason on 10 August 2012 16:25

If you are required to set the IP Address of the NTS-6000 manually, then first you must plug a standard USB keyboard into the unit before turning on the NTS-6000 unit. Once the unit is on please use the following steps to set the IP Address manually.

 

Type D

Press Enter

Set the Edit DHCP to N

Press Enter

Type S to save

Type I to Edit IP Address

Press Enter

Type in new IP Address (xxx.xxx.xxx.xxx)

Press Enter

Type S to save

Type M to Edit Subnet Mask

Type in the Subnet Mask (255.255.255.xxx)

Press Enter

Type S to save

Type G to Edit Gateway

Type in the Gateway (usually 192.168.0.1)

Press Enter

Type S to save

Reboot the System
(0 vote(s))
Helpful
Not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please complete the below captcha challenge (we use this to prevent automated submissions).