Debugging NTS-6001-Radio Firmware 10 and Below
Posted by Stuart Thomason, Last modified by Uzair A. on 09 February 2016 12:44

Please note: These debugging instructions are for Version 10 and Below. If you require Version 11 and above instructions, please click here.

Follow the instructions below to debug and NTS-6001-Radio unit.


Debugging the NTS-6001-Radio (for advanced users)

Log-in to the web admin page. The default username is “admin”, and the default password is “password”. Then go to “Configure SSH Access” and enable SSH.

To connect via SSH using putty (download link below) the default username is "root" and the default password is "galleon".

Press "q" followed by enter to break out of the menu system.

Now stop the Radio service using the command below:

Note: In the command below the single speech marks are "Acute" on an English keyboard they are generated by using the key above tab (failing that copy and paste the command).

kill `pidof radioclkd`

And restart the service using the following command:

radioclkd -t clk

You should see debug information like this if the Radio is synchronised:

DCD:   1    0      1668

DCD:   2    0      1668

DCD:   3    0      1668

DCD:   4    0      1668

DCD:   5    0      1668

DCD:   6    0      1668

DCD:   7    0      1668

DCD:   8    0      1668

DCD:   9    0      1668

DCD:   10   0      1668

DCD:   11   0      1668

DCD:   12   0      1668

If you receive nothing check the cabling, correct reception should be one message per second.

Note: When you have the antenna working break out of the debug with “ctrl + c” and then reboot the unit using the command “reboot”.

Putty Download Link:

http://the.earth.li/~sgtatham/putty/latest/x86/putty.exe

(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please complete the below captcha challenge (we use this to prevent automated submissions).