Resetting the NTS-6001 Bios
Posted by Stuart Thomason on 09 August 2012 14:59

Resetting the NTS-6001 BIOS

Boot the unit with a monitor and keyboard attached and hit the num pad delete key repeatedly to get to the bios.

In the bios go to the [EXIT] tab and then to “Load failsafe defaults” and hit [OK] in the confirm dialogue box.

Then go to the [ADVANCED] tab and select “Super IO Configuration” from here you want to change the following:

Note: Make a note of what these settings are on before you change them as it will help with debugging the unit.

Serial Port 1 IRQ from 11 to 4

Serial Port 2 IRQ from 10 to 3

Then press [F10] to save and exit and [OK] in the confirm dialogue box.

(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please complete the below captcha challenge (we use this to prevent automated submissions).