Knowledgebase
1Whitepapers 61Network Time Servers (NTS) 8Time Servers (TS) 7Atomic Clocks (AC) 6Digital Clocks
Knowledgebase: Network Time Servers (NTS)
Wiring Instructions - GPS Antenna - 8 Core Cable
Posted by , Last modified by on 14 July 2021 14:53

Extending the GPS antenna with 8 Core Cable

If you purchased your antenna on or after 11/02/2021 and your antenna looks like the photo above, please follow the instructions below.

  1. Cut the 15-way D-type connector off the antenna cable, ensuring you have plenty of slack cable for the next steps.
  2. Using the wiring schematic below, wire the antenna cable into the terminal block.
  3. Using the wiring schematic below, wire your 8-core extension cable to the other side of the terminal block.
  4. Using the wiring schematic below, wire the 15-way D-type connector onto the end of the 8-core extension cable.

Note: The supplied junction box is not weatherproof.

Extending the Old GPS antenna with 8 Core Cable

If you purchased your antenna before 11/02/2021 and your antenna looks like the photo above, please follow the wiring schematic below:

GPS 8 Core Wiring

GPS 8 Core Wiring

GPS 8 Core Wiring

(0 vote(s))
Helpful
Not helpful
Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please complete the below captcha challenge (we use this to prevent automated submissions).