Knowledgebase : Digital Clocks > SignalClocks
By default the Digital Clock will have DST Setting input, but they are not active. The use of the 'U' Command will result in the clock returning "DST Values Not Set!" You must first enter the settings that are correct for your time-zone using the 'V' Com...
The following information is only applicable to clocks using Firmware version 1.6A or above. To find out which Firmware version your clock has, use the 'K' command (see page 8 of manual). New command instructions Referring to page 8, and the item mark...
For use with Windows based servers, there is a slight workaround to get the clocks to sync. You will need to install our software called TimeSync onto a Windows 7 or newer PC/Server (do not install TimeSync on your domain controller). Set TimeSync to use...
This is the Hardware Manual for the SignalClocks. It will provide information regarding the installation and setup of the hardware. It also covers debugging and troubleshooting the unit. If your clock is running version 1.6A or higher of the firmwar...