We are aware of an issue with the NTS-4000 units running firmware older than 6.1 showing an incorrect date as of the 1st of January 2015.
The problem can be easily fixed by updating the firmware on your unit.
First you will need to download the software used to program the unit and the firmware file, both available in the zip file below.
Download NTS-4000 Firmware Version 6.2
Note: To make things easier extract the zip file to somewhere you can easily access like the desktop.
With most zip software, you can simply right click the zip file for extraction options.
Then install the NTS-4000 configuration client (SETUP.EXE)
When you have installed the NTS-4000 Configuration Client open the software and click on the magnifying glass in the top left of the application.
Note: You may need to allow firewall access if this is the first time you have used the software.
The magnifying glass searches your network for NTS-4000 units and will list them in the box below when it finds them.
To update the firmware on a unit click on the unit then click on the update firmware button (The third button along).
Enter the password or if there is no password set simply click "ok".
You will then be asked to locate the firmware file from the zip that you have downloaded.
The software is then sent to the unit this takes upto five minutes.
After this, you should receive a message telling you that the firmware was successful.
Your unit should now be running version 6.2 of the software.
If, during the update, you receive an error code (usually a negative error code) this is due to the software not being able to access the unit.
You should check that the windows firewall and your network firewall allow both TCP and UDP access to the NTS-4000.
Your local network administrator should be the first point of contact for these errors.
